What I am looking for is when Netapps comes out with code that will allow you to do a snap shot on a qtree basis. That will help data managment out big time.

KEVIN NOLL

-----Original Message----- From: Wurster, Richard M DSTI [mailto:rick.wurster@SBCCOM.APGEA.ARMY.MIL] Sent: 21 March 2002 18:49 To: 'Joe Luchtenberg'; toasters@mathworks.com Subject: RE: THE NEW REDHOOK Snapmirror using QTREE's

Sounds great, but when can we get our hands on Data OnTap 6.2???????

-----Original Message----- From: Joe Luchtenberg [ mailto:joe.luchtenberg@data-line.com mailto:joe.luchtenberg@data-line.com ] Sent: Thursday, March 21, 2002 12:58 PM To: 'Noll, Kevin'; toasters@mathworks.com Subject: RE: THE NEW REDHOOK Snapmirror using QTREE's

SnapMirror Qtree-level product enhancement was announced Monday. Product information is updated on the public website by now. To summarize:

- Requires ONTAP 6.2 - Single destination volume can host mirrored data for multiple source filers' qtrees - Destination qtree is read-only, but it can reside in a read-write volume on the destination filer - Each destination volume supports up to 29 mirrored qtrees; cannot cascade - Works at a logical file level, so it does NOT transfer FILESYSTEM metadata

==> protection against file corruption at destination site, which previously

would have been replicated with volume-level SnapMirror - Dramatically improves capacity management for destination filer with multiple sources - Can replicate smaller data sets, further reducing capacity requirements, while improving bandwidth and CPU overhead loads; however, if mirroring the entire volume it does take longer and use more capacity than volume-based SnapMirror (approximately 5% overhead compared to volume-level SnapMirror) - Changing between volume- and qtree-level (in either direction) requires a new level 0

HTH.

Joe

Joe Luchtenberg Dataline, Inc.

Email: joe.luchtenberg@data-line.com Phone: 757-457-0504 (direct line) 757-858-0600 (front desk) 757-285-1223 (mobile) Fax: 757-858-0606

Please visit us at www.data-line.com

-----Original Message----- From: Noll, Kevin [ mailto:kevin.noll@cgey.com

mailto:kevin.noll@cgey.com ]

Sent: Thursday, March 21, 2002 12:31 PM To: toasters@mathworks.com Subject: THE NEW REDHOOK Snapmirror using QTREE's

HI

I would like to know if with the new Redhook, if it will be possible to do snap shots on a qtree basis.

Thanks KEVIN NOLL

---

---

" This message contains information that may be privileged or confidential and is the property of the Cap Gemini Ernst & Young Group. It is intended only for the person to whom it is addressed. If you are not the intended recipient, you are not authorized to read, print, retain, copy, disseminate, distribute, or use this message or any part thereof. If you receive this message in error, please notify the sender immediately and delete all copies of this message ".

---

---