I'm not sure how you can accomplish this without taking it down, even though temporarily:

You can reconfigure your current vif to multimode and then make it part of a larger singlemode\multilevel vif, but that means a VIF reconfig, or a bit more clean is to make each sub interface a multimode vif and leave the current singlemode vif intact.

Here's the problem: you can add another interface to a VIF without interruption - but you cannot take one away.

I'd recommend configuring the /etc/rc file to have what you want, then rebooting.

If you have cluster, you can probably do this with a failover/failback (failover, edit the /etc/rc, then failback with the 'new' config).

Glenn

________________________________

From: owner-toasters@mathworks.com [mailto:owner-toasters@mathworks.com] On Behalf Of Darish Rajanayagam Sent: Tuesday, April 03, 2007 5:48 PM To: toasters@mathworks.com Subject: iscsi vifs

Greetings:

Currently, my ISCSI setup consist of a single mode vif on the NetApp side - this connects to a dedicated switch for the ISCSI traffic. I have active/passive clusters connected to this switch with dedicated NICs for ISCSI connectivity. On the server side, I run Snap Drive 4.1 and MS ISCSI Initiator.

I would like to change this to the following.

1. Create two multimode vifs (each vif connecting to a separate switch - the switches would then be bridged)

2. Create a second level single mode vif consisting of the above two multimode VIFs - so only one vif is active at any one time.

3. The second level single mode vif will have the same IP address as it is now.

If I make the above change, would this affect any of the currently mapped ISCSI connections? Do I need to re-map it through MS ISCSI initiator - IP addresses are not changing, would this cause any changes on the server side?

Thanks,

Darish.