Hi,

Does anyone have HP Ultrium 2 working directly off the back of a filer yet ?

I understand NetApp are currently testing and support is due for relase some time in April but I do not have a confirmed date. I am guessing this will take the form of a dynamic tape configuration file for using in the etc/tape_config directory.

I have created a dynamic tape config file but am struggling to get the HP hex codes for density codes (l,m,h and a) and corresponding density alogrithms which are required for the tape_config file ?

Anyone have the hex codes I require for the HP Ultrium 2 or a working dynamic tape config file ?

We are running DOT 6.3.1R1 ....

Thanks

Dave Dalby Systems Engineer - Storage Solutions ASI Solutions - Perth

**** ASI Solutions Disclaimer **** The material transmitted may contain confidential and/or privileged material and is intended only for the addressee. If you receive this in error, please notify the sender and destroy any copies of the material immediately. ASI will protect your Privacy according to the 10 Privacy Principles outlined under the new Privacy Act, Dec 2001.

This email is also subject to copyright. Any use of or reliance upon this material by persons or entities other than the addressee is prohibited.

E-mails may be interfered with, may contain computer viruses or other defects. Under no circumstances do we accept liability for any loss or damage which may result from your receipt of this message or any attachments. **** END OF MESSAGE ****