Sorry if this is a really basic question. I booted off of floppies (5.3.5R2, I believe it was), and reinitialized the array, took a couple of hours, all seemed to go well. But when it was done, it complained about the firmware revision on all the drives, and recommended I run disk_fw_update. However that command does not seem to be one of the available commands when booting from the floppy (and I can't boot from the array yet).
What am I missing? Again, sorry if this is a pretty basic question. Any help would be appreciated.
u certainly don't have this command available because the system is not fully install after zeroing all disk in order to install a new system, do it, then you should have this command if the command is still unavailable try this : rc_toggle_basic disk_fw_update
if you still have error message, you could have to get last firmware for disks you have and the last qual_devices file you can get them on now.netapp.com site (look for disk fw and matrix)
hth bye
Professor Frink wrote:
Sorry if this is a really basic question... I booted off of floppies (5.3.5R2, I believe it was), and reinitialized the array, took a couple of hours, all seemed to go well. But when it was done, it complained about the firmware revision on all the drives, and recommended I run disk_fw_update. However that command does not seem to be one of the available commands when booting from the floppy (and I can't boot from the array yet).
What am I missing? Again, sorry if this is a pretty basic question. Any help would be appreciated.
-
Professor Frink -
Stephane Bentebba