The hardware guide for your filer (downloadable from NOW) defines the pins on the console port, and the required terminal settings.
The minimal required pins are:
Pin 2 RxD Pin 3 TxD pin 5 Ground
You need to set your emulator to 9600, 8 bits, no parity, XON/XOFF (or no flow control).
Regards, Andrew
-----Original Message----- From: owner-dl-toasters@netapp.com [mailto:owner-dl-toasters@netapp.com]On Behalf Of Erik Ahlstrom Sent: 02 February 2000 14:34 To: Ronan Mullally Cc: toasters@mathworks.com Subject: Re: console cable pinout
You should use an null-modem kable or X-tp cable trough RJ45
- DB-9, and
make sure that you are using Software hand-shake, ie, xon-xoff.
I'm using this config and it works fine for me.
/erik
\/// (o o)-------------ooO(_)Ooo----------------------------------------- Erik Ahlström, ProAct Datasystem eah@proact.se, Systems Engineer Vx: +46 8 6236660 Ph: +46 8 6236577 Fx: +46 8 6231856 Mob:+46 709 844102 ===============================================================
On Wed, 2 Feb 2000, Ronan Mullally wrote:
After almost two years without a toaster I've finally come out of the wilderness and am once again the proud "owner" (ok, admin) of a nice shiny new toaster. Pity they're not as shiny as they used to be in the Good Ol' Days :(
I'm trying to connect this beastie to a console server.
Specifically
a Linux box with a Cyclades Ze multiport serial card. The Cyclades presents its ports using an expansion box with RJ45 female ports.
I haven't been able to get this to talk to the toaster's
console port :(
I've tried various combinations of straight-through and null-modem adaptors with standard ethernet and roll-over drop cables
with no joy.
Can anybody point me in the direction of the pinouts I need in a RJ45 - DB-9 adaptor that will work with a roll-over drop cable?
For reference, I've got the Cyclades ports talking to cisco
kit (3600s)
using a roll-over cable. I've also got them talking to
Foundry switches
using the same roll-over cable with an adaptor using the
pinout below.
RJ45 DB-9 Signal Pinout Pinout Signal TxD 3 --------------------- 2 RxD RxD 6 --------------------- 3 TxD Gnd 4 --------------------- 5 Gnd RTS 1 ----+ +----- 7 RTS CTS 5 ----+ +----- 8 CTS DTR 2 ----+ +----- 4 DTR DCD 7 ----| |----- 1 DCD DSR 8 ----+ +----- 6 DSR-Ronan
-
Bond, Andrew