Hi Steve, You can use these two commands the first will check to see if you need to reallocate and second will do the job :)

wafl scan measure_layout <vol | file> wafl scan reallocate <vol | file>

Thank you Michael A Schipp ASI Solutions IT LAN/WAN Administrator E-Mail : mschipp@asi.com.au Visit us at http://www.asi.com.au

-----Original Message----- From: Steve Evans [mailto:sevans@foundation.sdsu.edu] Sent: Tuesday, 28 January 2003 4:59 AM To: toasters@mathworks.com Subject: Adding Disk to Volume

Okay I know this has been brought up lately, but I'm not sure what the outcome of it was.

I need to add a disk to my root volume. What should I do (or should I do anything) to spread the data across the new disk evenly?

Steve Evans SDSU Foundation (619) 594-0653

**** ASI Solutions Disclaimer **** The material transmitted may contain confidential and/or privileged material and is intended only for the addressee. If you receive this in error, please notify the sender and destroy any copies of the material immediately. ASI will protect your Privacy according to the 10 Privacy Principles outlined under the new Privacy Act, Dec 2001.

This email is also subject to copyright. Any use of or reliance upon this material by persons or entities other than the addressee is prohibited.

E-mails may be interfered with, may contain computer viruses or other defects. Under no circumstances do we accept liability for any loss or damage which may result from your receipt of this message or any attachments. **** END OF MESSAGE ****