Dont know if this helps, but here is my how to on NDMP
Task NDMP Copy
Commands: options ndmpd Outputs the options for ndmp. Ndmpd status Status of NDMP Ndmpd on/off Switches ndmp on / off Options ndmpd.enable on Enables NDMP Options ndmpd.enable off Disables NDMP Options ndmpd.preferred_interface Specifies the interface through which ndmp would send data Steps to enable NDMP
Options ndmpd.enable on Options ndmpd.preferred_interface <interface name>
Commands to copy data through NDMP
Volumes, Qtrees, Directories can be copied through NDMP using the below syntax
ndmpcopy -sa username:password -da username:password <source> <destination>
where sa and da are source/destination filer authentication <source> and <destination> are of the form [<filer>:]<path>
Limitations:
Individual file(s) cannot be copied through NDMP Not preferred for transfer for small data
Kevin Noll tel +44 7801765042 Cap Gemini Ernst & Young
-----Original Message----- From: Kennedy, Jeffrey [mailto:jkennedy@qualcomm.com] Sent: 18 December 2002 16:01 To: Collin Park; David J. Haber Cc: toasters@mathworks.com Subject: RE: Ndmpcopy again
I believe the problem is that ndmpcopy was only introduced as part of OT in 6.2; previously it required a platform specific binary. The original poster's 840 filer is running 6.1.1.
~JK
******************************************************************************************** " This message contains information that may be privileged or confidential and is the property of the Cap Gemini Ernst & Young Group. It is intended only for the person to whom it is addressed. If you are not the intended recipient, you are not authorized to read, print, retain, copy, disseminate, distribute, or use this message or any part thereof. If you receive this message in error, please notify the sender immediately and delete all copies of this message ". ********************************************************************************************
-
Noll, Kevin