All,

Had an original F740 with two full shelves of 36F disks. Added a new F740 (for snapmirror purpose) with the same configuration but it came with the new 34F+ disks. Configured the new filer with the identical volume configuration for snapmirror. Original filer was running 5.3.7r3 while the new filer is running 6.1r1 because of the requirement of 34F+ disks. My issues are:

(1) Anybody has the information on the "right-size" of the 34F+ disk? My understanding is that 36F has 34,500 KB. The yellow flyer says that 34F+ has lesser capacity but that does not help very much, how much lesser? (2) Because of the lesser capacity (I guess), the target volume can not be snapmirrored. I have to rearrange the volume configuration making the target volumes by one disk more than the source volume, only after that the snapmirror went through.

The intention of the snapmirror is for disaster recovery. In the event that the source filer is not available, the target filer will be changed from snapmirrored status to regular volume. When the original source filer is ready for operation again, what is the best practice to move the data back?

(3) Snapmirror back on the reverse direction would not work because now the original source filer volume is smaller than the original target volume. (4) Would vol copy falls into the same restriction of target volume has to be equal or larger? In my case, they could not be equal because of one is using 36F and the other is using 34F+.

Thanks in advanced for your comments/suggestions.

Nic