level 1vif : multi1 + mutli2
level 2 vif: single1 (out of 2 multi)
vlans: 2 vlans on top of single 1
There is no default management interface on a 3020 or a 3050 (or a
3070 for that matter). There are 4 interfaces that come with the
system. You can use them in the way you had described in your first
post, then use vlan tagging, to segment your management traffic from
your production traffic. So your production still gets 4 interfaces,
and your management interface is on a separate vlan from your
production network.
This is a different configuration then you were previously using, but
that's the nature of this device. Alternately, you could purchase
another nic from Netapp for management use. I'm sure you could
negotiate a lower price then usual, since it's only going to be used
as a management interface.
-Blake
On 1/3/07, Linux Admin sysadmin.linux@gmail.com wrote:
Blake,
Thanks again.
so is there a "default" management interface out the 4?
i was going to use 2 nicks to 1 switch (active) and 2 nicks to 2 switch
(passive)
3 nics, odd number to work with vifs is very strange.
Now some people say they vif all 4 into one vif and use that for mgmt
and
data.
how is it possible?
i am still confused
On 1/3/07, Blake Golliher thelastman@gmail.com wrote:
I meant using vlans to separate your management traffic from your
production data traffic. Most filers before the 3000 had one on board
interface. Even on the 980 it had a 100mb interface. With the 3000's
and the 6000's there are now 4 or 6 on board 1g interfaces that can be
used for either management or data throughput.
If you workload is dispersed enough that you need 4 full 1g interfaces
for just production traffic, or your security need to be segmented
that management traffic can't touch production traffic, then perhaps a
separate gig card is required.
-Blake
On 1/3/07, Linux Admin sysadmin.linux@gmail.com wrote:
Blake,
Thanks! So which one is managment then?
I see dedicated managemnet iterface on all filers but 3020.
Or do you manage over the data IP?
Thanks
On 1/3/07, Blake Golliher <thelastman@gmail.com > wrote:
You can use vlan tagging on it that final multi mode trunk vlan.
There should be 3 slots available for expansion cards if you need
a
dedicated interface for managment. Depending on how much storage
is
attached to this config, you should be able to use one of those
slots
for a network card.
-Blake
On 1/3/07, Linux Admin < sysadmin.linux@gmail.com> wrote:
Folks,
Not familiar with 3020 series at all. I see 4 nics (e0a, e0b,
e0c,e0d)
on
the back of each head.
Does it mean I have sacrifice one to be management and only 3
are
available
as data?
Have NetApp change things? Or can I used all 4 in single/multi
vips?
I was going to do e0a and e0c in single A, e0b and and e0d in
single
B,
and
Multi VIP C on top of Sinlge A and Single B.
Not sure what to do about management.
Thanks for help
Linux Admin