Hi -
Once again, Netapp tech support seems to be taking their sweet time about responding to my support email, so I'm going to folks that actually respond...
Got this in the logs of one of my 720s. Is this telling me I've got bad RAM? It hasn't recurred since that date, but still worries me.
Sun Apr 30 12:01:28 PDT [de1]: 11 CORR SYS ERR 201 eia:6cfce0058930000 fs:1ee0015 eis:0 isr:80000001 Sun Apr 30 12:01:28 PDT [de1]: ...SYS ECC error: address=0x6cfce00, bit=19, DIMM=J28 Sun Apr 30 12:02:43 PDT [de3]: 12 CORR SYS ERR 201 eia:3ced0058930000 fs:1ee0015 eis:0 isr:80000001 Sun Apr 30 12:02:43 PDT [de3]: ...SYS ECC error: address=0x3ced00, bit=19, DIMM=J28 Sun Apr 30 12:02:50 PDT [de3]: 13 CORR SYS ERR 201 eia:47634058930000 fs:1ee0015 eis:0 isr:80000001 Sun Apr 30 12:02:50 PDT [de3]: ...SYS ECC error: address=0x476340, bit=19, DIMM=J28 Sun Apr 30 12:03:09 PDT [de2]: 14 CORR SYS ERR 201 eia:6cfce0058930000 fs:1ee0015 eis:0 isr:80000001 Sun Apr 30 12:03:09 PDT [de2]: ...SYS ECC error: address=0x6cfce00, bit=19, DIMM=J28 Sun Apr 30 12:03:37 PDT [de3]: 15 CORR SYS ERR 201 eia:6cfce0058930000 fs:1ee0015 eis:0 isr:80000001 Sun Apr 30 12:03:37 PDT [de3]: ...SYS ECC error: address=0x6cfce00, bit=19, DIMM=J28
-j
----- Original Message ----- From: "Jamie Lawrence" jal@thirdage.com To: toasters@mathworks.com Sent: Saturday, May 06, 2000 3:25 PM Subject: Error from filer; bad RAM?
Hi -
Once again, Netapp tech support seems to be taking their sweet time about responding to my support email, so I'm going to folks that actually respond...
Got this in the logs of one of my 720s. Is this telling me I've got bad RAM?
There was an error in the J28 DIMM that was corrected, a couple of times.
It hasn't recurred since that date, but still worries me.
Since it hasn't happened again, I wouldn't worry about it. The timing seems to indicate that perhaps something was going on unusual at that time, perhaps a raid scrub or a heavy load from cron or somesuch? It is not unusual to see more errors during times of heavier stress.
You might want to consider reseating that DIMM just to make sure it has a good connection. Then I wouldn't worry unless you start seeing a LOT more errors. But support may tell you different.
Bruce