Hi & Thanks for the support you're about to give =)

NETAPP is a FAS3050C: netapp1 and netapp2

I've installed the ESX FCP host utilities 5.0R1, successfuly but the configuration fails WARNING: The installation process was unable to login to all the connected NetApp storage system(s) due to improper credentials: Please specify the correct credentials for the following controller(s): netapp1 The script was unable to determine the correct settings for your configuration. After the proper credentials have been determined, run the following commands: /opt/netapp/santools/config_hba --configure --access <controller>:<password>

So I enter the following command since were not using SSL ./config_hba --configure --access netapp1:1234 and gives me the following: WARNING: The installation process was unable to login to all the connected NetApp storage system(s) due to improper credentials: Please specify the correct credentials for the following controller(s): netapp2 when replace netapp1 with netapp2 the error message changes below from netapp2 to netapp1, confusing hey.

We allocated storage to the ESX server from both node netapp nodes.

Any ideas on what i should do i already have a case open 2000474215 for those with access.

Thanks again