Floppy booting 5.3.6R2 and then downloading that release should solve the problem. Call customer service if you are having problems with the procedure. Once 5.3.6R2 is loaded you should have no problem turning quotas back on.
Jeff
-----Original Message----- From: Fairchild, Peter [mailto:Peter.Fairchild@netapp.com] Sent: Friday, August 11, 2000 6:42 AM To: Heller, Jeffrey; Krishnan, Prabhakar; Jiang, Perry Cc: toasters Subject: RE: user quota crashes filer
That doesn't fully answer the question. How does one deal with this problem *before* patching 5.3.6R2? Does one have to nuke the filer to get quota functional again?
-----Original Message----- From: Heller, Jeffrey [mailto:Jeffrey.Heller@netapp.com] Sent: Thursday, August 10, 2000 6:14 PM To: Krishnan, Prabhakar; Jiang, Perry Cc: toasters Subject: RE: user quota crashes filer
This problem is fixed in 5.3.6R2 which is on NOW as of today.
-----Original Message----- From: Prabhakar Krishnan [mailto:kpkar@netapp.com] Sent: Thursday, August 10, 2000 1:54 PM To: Jiang, Perry Cc: toasters Subject: Re: user quota crashes filer
this was a bug.
- patch is availabe , contact the SE/CS
- fixed in the next release
"Jiang, Perry" wrote:
Hi, I have a 740 filer with Data OnTAP 5.3.6 I put a quota entry for username "perry" into /vol/vol0/etc/quotas perry user 50M -
But there is no entry for "perry" in /vol/vol0/etc/passwd,
so there is no
UID for perry(No NIS running, of course). When I run "quota on vol0", the filer crashes.
I have to boot up the filer from floppy disk, remove the
entry of "perry" in
/vol/vol0/etc/quotas file, then reboot the filer.
After the filter is up, everything is ok. However, I can't
enable quota
anymore. Every time I run "quota on vol0", the filer would crash.
The only thing I have in /vol/vol0/etc/quotas now is couple
of entries for
Qtree quota.
Can anybody explain when the filer still crashes after I
remove the "perry"
entry? How can I make the quota work again? Do I have to rebuild the filer?
Thanks
Perry Jiang
-
Heller, Jeffrey