If FE means Fast Ethernet, the answer is yes for the PCI-based models (220, 330 & 540). You need software release 4.X to support full duplex.
Arnie from Netapp
At 12:42 PM 4/8/97 -0400, Tom Yates wrote:
anyone know if the FE ports on the toasters can run full duplex?
Tom Yates - Unix Chap - The Mathworks, Inc. - +1 (508) 647 7561 MAG#65061 DoD#0135 AMA#461546 1024/CFDFDE39 0C E7 46 60 BB 96 87 05 04 BD FB F8 BB 20 C1 8C
If FE means Fast Ethernet, the answer is yes for the PCI-based models (220, 330 & 540). You need software release 4.X to support full duplex.
We're running 4.0.1c with 2 100tx-fd cards plugged into a cisco cat 5000. The ports on the cat are set to auto detect 10/100 half/full duplex but they keep deciding the toaster's interfaces are half duplex, any ideas?
On Wed, 9 Apr 1997, Ronan Mullally wrote:
We're running 4.0.1c with 2 100tx-fd cards plugged into a cisco cat 5000. The ports on the cat are set to auto detect 10/100 half/full duplex but they keep deciding the toaster's interfaces are half duplex, any ideas?
Almost the same setup here.....on the Cat5k you need to do this:
set port speed m/n 100 set port duplex m/n full
where m and n are the card slot and interface number, respectively.
-- Dave Pascoe | mailto:dave@mathworks.com | Voice: 508.647.7362 KM3T | http://www.mathworks.com | FAX: 508.647.7002 PGP fingerprint: 53 AD 71 88 2F AA 45 AC D0 2E 68 91 71 77 39 AF
We're running 4.0.1c with 2 100tx-fd cards plugged into a cisco cat 5000. The ports on the cat are set to auto detect 10/100 half/full duplex but they keep deciding the toaster's interfaces are half duplex, any ideas?
Almost the same setup here.....on the Cat5k you need to do this:
set port speed m/n 100 set port duplex m/n full
Ahh, I only every tried the latter, which kept telling me the port was in auto-sensing mode.
Thanks.
Set the ports on the Cat 5000 to be 100-fd. Turn off the auto detect. That should solve the problem.
Ronan Mullally wrote:
If FE means Fast Ethernet, the answer is yes for the PCI-based models (220, 330 & 540). You need software release 4.X to support full duplex.
We're running 4.0.1c with 2 100tx-fd cards plugged into a cisco cat 5000. The ports on the cat are set to auto detect 10/100 half/full duplex but they keep deciding the toaster's interfaces are half duplex, any ideas?
-- Ronan Mullally 'In the Beginning there was Network Manager nothing, which exploded.' Ireland On-Line -- Terry Pratchett.
-
Arnie Thompson -
Dave Pascoe -
Ronan Mullally -
Timothy A. McCarthy