FW: reuse old NetApp shelf

-- Scott Fischmann Union Computer Exchange, Inc. 6233 Idylwood Lane Minneapolis, Minnesota 55436 phone: (952) 935-7282 | fax: (952) 935-5056 email: scott@unioncomputer.com mailto:scott@unioncomputer.com "Helping our customers make each dollar go further - since 1991!" Iain Barnetson wrote on 3/26/2005, 4:41 PM: yeah yeah yeah Am I in the Ebay forum or something? I've had more replies offereing to buy these things or sell me something else than answers to the question...........good grief!! Please DO NOT email me trying to sell me something or buy something from me, ok? Thanks. _____ From: Timothy Naple [mailto:tnaple@BERKCOM.com mailto:tnaple@BERKCOM.com ] Sent: 26 March 2005 17:29 To: Iain Barnetson Subject: RE: reuse old NetApp shelf Ian, I could offer a trade for some generic shelves and disks that work fine on Windows. I could use the NetApp storage. If that sounds at all interesting, let me know. Thanks, Tim Timothy Naple tnaple@berkcom.com mailto:tnaple@berkcom.com 510-384-1033 Cell 510-644-1599 Office 510-644-1598 Fax Berkeley Communications Corporation 2990 San Pablo Avenue Berkeley, CA 94702 http://www.berkcom.com http://www.berkcom.com/ -----Original Message----- From: Iain Barnetson [mailto:Iain.Barnetson@Halliburton.com mailto:Iain.Barnetson@Halliburton.com ] Sent: Saturday, March 26, 2005 5:20 AM To: toasters@mathworks.com mailto:toasters@mathworks.com Subject: RE: reuse old NetApp shelf I've tired low level formatting two of the disks using the Qlogic card bios facility which suceeded with no error messages. I then came back into windows and still couldn't do anything with the disks. I've tried creating a partition using both diskpart and gdisk32 but still no joy. Gdisk32 creates a partition but still windows wants to initialize the disks but can't. diskpart sits there using cpu cycles, so far for 3 hours, and doesn't seem to be doing very much. Any ideas how I can get these drives in a usuable state? _____ From: Fox, Adam [mailto:Adam.Fox@netapp.com mailto:Adam.Fox@netapp.com ] Sent: 25 March 2005 17:14 To: Iain Barnetson Subject: RE: reuse old NetApp shelf You'll probably have to low-level format the drives to use 512 byte blocks. I'm guessing Windows isn't thrilled with the 520-byte blocks that NTAP uses. -- Adam Fox adamfox@netapp.com mailto:adamfox@netapp.com _____ From: Iain Barnetson [mailto:Iain.Barnetson@Halliburton.com mailto:Iain.Barnetson@Halliburton.com ] Sent: Friday, March 25, 2005 11:50 AM To: toasters@mathworks.com mailto:toasters@mathworks.com Subject: Re: reuse old NetApp shelf I've got a couple of NetApp DS14 fibre disk shelves from our "old" filers that I'd like to reuse. I attached one of the shelves to a server using a Qlogic 2200 card and although Windows detected the drives correctly I couldn't partition them or anything - no specific error message just saying that it couldn't. What I'm wondering is: Should I use the Qlogic card facility to low level format them? Will that make them usable in Windows? Any suggestions on how I can implement RAID with these disks other than Windows software RAID? Regards, Iain