What output are you getting from sysconfig -t on the filer? When I run this command, I get several device paths for the tape drive, and the type and compression are listed. Then I use the highest compression no-rewind device as the "path" on the Netbackup system.
I've also set the type of drive in Netbackup to '1/2" Cartridge 3 (hcart3),' but in my experience this doesn't affect the format/compression that will get written to the drive physically.
Fred --- Ken Williams kwillia@smud.org wrote:
Toasters!
I have been trying for a couple weeks now to get my 3020 to properly see an LTO Gen 3 FC Tape drive.
Environment: FAS3020, attached to Cisco MDS Fabric with ISL between two MDS9509s attached to HP Ultrium 3 LTO3 Drive.
The LTO3 drive is installed in a StorageTek L700 Library which fiber channel robotic control. The backup environment is Symantec Netbackup. There is no extra HBA cards in the FAS3020, so we are using the onboard card.
The Good: I can manually load a tape, the Filer sees the drive/tape.
The Bad: The system always reports back that the tape is a LTO1 200GB read only.
Naturally I tried several other tape drives and tape media, all with the same problem. I have 2 FAS940s that do not have any issue talking to LTO3 Tape drives.
I've downloaded the latest device configuration files from now, I've been working with the technical support at netapp. My best assumption is that the drives are in the wrong block mode.
Has anyone seen anything like this?
__________________________________________________________
Ken Williams Storage Administrator, Business Technology Operations Sacramento Municipal Utility District E-Mail: kwillia@smud.org Phone: (916) 732-6744 Cell: (916) 240-4213
__________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com