You are probably confused. Software based disk ownership indeed does not require that full loops/stacks or even shelves are assigned to the same filer. But for auto-assignment algorithm to work this is required. Later versions allow auto-assignment work for full shelves, thus you can mix full shelves from different filers on the same loop/stack. It is not default and has to be enabled.
So there is nothing to fix, it works as designed ☺ Actually I usually disable auto-assignment and do it manually, to be absolutely sure each disk belongs where it should.
--- With best regards
Andrei Borzenkov Senior system engineer FTS WEMEAI RUC RU SC TMS FOS [cid:image001.gif@01CBF835.B3FEDA90] FUJITSU Zemlyanoy Val Street, 9, 105 064 Moscow, Russian Federation Tel.: +7 495 730 62 20 ( reception) Mob.: +7 916 678 7208 Fax: +7 495 730 62 14 E-mail: Andrei.Borzenkov@ts.fujitsu.commailto:Andrei.Borzenkov@ts.fujitsu.com Web: ru.fujitsu.comhttp://ts.fujitsu.com/ Company details: ts.fujitsu.com/imprinthttp://ts.fujitsu.com/imprint.html This communication contains information that is confidential, proprietary in nature and/or privileged. It is for the exclusive use of the intended recipient(s). If you are not the intended recipient(s) or the person responsible for delivering it to the intended recipient(s), please note that any form of dissemination, distribution or copying of this communication is strictly prohibited and may be unlawful. If you have received this communication in error, please immediately notify the sender and delete the original communication. Thank you for your cooperation. Please be advised that neither Fujitsu, its affiliates, its employees or agents accept liability for any errors, omissions or damages caused by delays of receipt or by any virus infection in this message or its attachments, or which may otherwise arise as a result of this e-mail transmission.
From: toasters-bounces@teaparty.net [mailto:toasters-bounces@teaparty.net] On Behalf Of Mark Flint Sent: Tuesday, March 22, 2016 2:51 PM To: toasters@teaparty.net Subject: disk ownership question
Hi list. I have a 3170 running 8.0P1 7-Mode, and am having a problem with auto-assignment of disks. The unit reports that it can’t do auto-assign, because not all of the disks on the loop are owned by the same controller. I was under the impression that software ownership made that unnecessary (you can laugh), but it seems not. KB from 2014 says the same thing. So, question is, has anyone done anything like this (had to reassign a shedload of disks) to make auto-assign work, and could they pass any info on how I can fix this please?
Thanks,
Mark
