Use multi-pathing.
1 full shelf, 4 FC controllers Check the storage guide for configuration, but essentially, you connect one fc to the IN and another to the OUT. Do this for both A/B loops.
Now with 1 shelf, you have 4 paths to each disk and the filer should split between all 4 giving pretty good perfoamce from just 1 shelf.
Of couse, you can add more shelves as well.
--tmac Sent from my Verizon Wireless BlackBerry
-----Original Message----- From: "No More Linux!" no.more.linux@gmail.com
Date: Thu, 5 Jun 2008 14:47:13 To:tmac tmacmd@gmail.com Cc:"toasters@mathworks.com" toasters@mathworks.com Subject: Re: 1TB SATA, raid group size, 16TB limits etc
the point was that we needed 10TB of space on a new filer and a single 1TB drive shelf provides this but pretty much violates the redundancy and performance benefits of spreading load across multiple drives/shelves/controllers in an aggregate.
so to even make it somewhat more appropriate we would have to buy 2 shelves so the aggregate load would be more adequately spread but we still run up across the 16TB aggregate limit.
i guess the issue is with 1TB drives the whole 16TB aggregate limit is just plain silly and ridiculous.
maybe we should just go with the 500GB sata shelves and spread the load across more drives. im not sure i want to confine my aggregates to just 8 to 12 drives max.
On Thu, Jun 5, 2008 at 12:55 PM, tmac <tmacmd@gmail.com mailto:tmacmd@gmail.com > wrote: Let ontap figure where to put things.
Besides,. the recommended size is 14 for SATA and 16 for FC per raid group. Obviously, if you want to MAX out an aggregate at 16TB, you have to take into consideration you cannot do it in a single RAID group (well, I think you can, but it is not recommended!!). Therefore, your raid groups may look like 8+8 (maybe even 9+9), but you probably do not want 14+2 or 14+4.
Either way, you are eating the parity drives. Might as well make them balanced groups.
Oh, one more thing. Let ONTAP pick which disks to use. It will intelligently pick across shelves and controllers.
--tmac
On Thu, Jun 5, 2008 at 3:09 PM, No More Linux! <no.more.linux@gmail.com mailto:no.more.linux@gmail.com > wrote:
is the raid group recommended size still 16 with the new 1TB sata drives? basically we are pretty much limited to one shelf per aggregate--not sure how this is good thing.
is the 16tb limit going away anytime soon? it is becoming increasingly too restrictive as these larger drive sizes are introduced. or am i just supposed to create one shelf aggregates of 1tb drives from now on?
-- --tmac
RedHat Certified Engineer #804006984323821 (RHEL4) RedHat Certified Engineer #805007643429572 (RHEL5)
Principal Consultant