Thanks to you all for the inputs.
I found that enabling the CIFS SETUP was the way to enable access to the filesystem on the A controlle.
Now I have the setup file and the B controller is up and running - GREAT.
Have a nice weekend!
Glenn Walker wrote:
Why not just run the 'software install' command - no need for accessing the file system remotely.
-----Original Message----- From: owner-toasters@mathworks.com [mailto:owner-toasters@mathworks.com] On Behalf Of Amateur-FASadmin Sent: Friday, February 22, 2008 6:00 AM To: toasters@mathworks.com Subject: Re: Access to filers filesystem
You are right. I can see it on the A-controller by issuing a "Software List" command. But I can not figure out how to access the filers - file system. /etc.. and so on.
Is it because I only have licensed it for iSCSI and Cluster ??
Regards Jesper Harder
Amateur-FASadmin wrote:
Dear Nabbler's
I have two fas200 or rather IBM N3700 A20. I have reconfigured the B controller for a new diskshelf by removing
the
aggr and done a ctrl-C for a total new install.
I originally did this and upgraded to IBM Ontap 7.2.1.1 - But now I
can't
find that on IBM.com.
On the filers A controller under "software list" I can see the "7211_setup_m.exe"
But I simply can not find a way to access the filers filesystem or any other way to pick that file. I need this for the B controllers installation.
Can you help me ?
Thanks :-)
regards Jesper
-I have a high Google IQ
View this message in context: http://www.nabble.com/Access-to-filers-filesystem-tp15618954p15631517.ht ml Sent from the Network Appliance - Toasters mailing list archive at Nabble.com.
=)=)=)=)=)=)=)=)=)
----- -I have a high Google IQ