There was a spares_zero command (priv set diag). However:
1.) I don't know if the command existed in 5.3.X 2.) 'priv set diag' isn't the privileged mode in 5.3.X - I don't remember the proper one (and am quite frankly too lazy to look it up at the moment).
Another option is to boot (with floppies) to the maintenance mode and choose option 4 - it wipes all the disks...
-----Original Message----- From: owner-toasters@mathworks.com [mailto:owner-toasters@mathworks.com] On Behalf Of Sphar, Mike Sent: Wednesday, February 15, 2006 5:42 PM To: toasters@mathworks.com Subject: wiping disks on an old F230
We've got an old F230 that I was finally able to decommission today, and I figure even though I've deleted all the data it would probably be a good idea to scrub the disks a bit for security purposes.
Problem is I just can't remember (and can't seem to find searching around NOW) what the best way to do that back in OnTap 5.3.7R3D18 was. I know I could do disk sanitize now, but not sure what if anything was available in older versions. Any suggestions?
(I fully concede that I might be having a complete brain failure about the painfully obvious solution I should already know. But I even searched around NOW a bit and couldn't find an answer.)
-- Michael W. Sphar - IS&T - Lead Systems Administrator SMBU Engineering Support Services, BMC Software