Thanks all. Now I am a little embarrassed, it never occurred to me that it was a separate environment than the interactive shell.
Thanks!
On 02/02/2012 09:01 AM, Vervloesem Wouter wrote:
This is normal because the statit command is a 'priv set diag' command. you should do something like "ssh<host> priv set advanced; statit -b".
Mvg, Wouter Vervloesem
Neoria - Uptime Group Veldkant 35D B-2550 Kontich
Tel: +32 (0)3 451 23 82 Mailto: wouter.vervloesem@neoria.be Web: http://www.neoria.be
Op 2-feb.-2012, om 14:35 heeft Jeremy Page het volgende geschreven:
Does anyone know if there is a way to get statit to run from ssh/rsh& have the output redirected? For instance if I do ssh<host> vol status I get the results displayed to stdout but if I do ssh<host> statit -b it says command not found.
Please be advised that this email may contain confidential information. If you are not the intended recipient, please notify us by email by replying to the sender and delete this message. The sender disclaims that the content of this email constitutes an offer to enter into, or the acceptance of, any agreement; provided that the foregoing does not invalidate the binding effect of any digital or other electronic reproduction of a manual signature that is included in any attachment. _______________________________________________ Toasters mailing list Toasters@teaparty.net http://www.teaparty.net/mailman/listinfo/toasters
Please be advised that this email may contain confidential information. If you are not the intended recipient, please notify us by email by replying to the sender and delete this message. The sender disclaims that the content of this email constitutes an offer to enter into, or the acceptance of, any agreement; provided that the foregoing does not invalidate the binding effect of any digital or other electronic reproduction of a manual signature that is included in any attachment.