Hello,
We have mixed ESH2 and ESH4 within the same chain. The only thing is that we set the speed of the ESH4 to 2Gbit. We are running in this manner for several months already and we haven't had any issues.
Regards, Rik Daniëls
-----Original Message----- From: owner-toasters@mathworks.com [mailto:owner-toasters@mathworks.com] On Behalf Of Steve Losen Sent: donderdag 24 juni 2010 13:48 To: toasters@mathworks.com Subject: DS14MK2 and DS14MK4 shelves on same chain?
Hello Toasters,
We had a downtime on a FAS6040 clustered pair to add Ethernet cards and add two new shelves of FC disks. I had to rearrange the cabling of the shelf chains because the new shelves could not be installed next to the "tail" shelves on the chains.
The 6040s would not boot up because the aggr containing the root volume was incomplete. The shelf lights indicated a problem with the chains I had worked on.
While inspecting my cabling, I noticed (for the first time) that the new shelves are ESH4 while the old selves are all ESH2. I also noticed that the ESH4 shelves are set to 4Gbit speed while the ESH2s are 2Gbit.
Not knowing if I can mix ESH2 and ESH4, I disconnected the new shelves in such a way that they can be "hot added" later to the tails of the chains. Then the filers booted up fine.
Question:
Can I hot add the ESH4 shelves to the ESH2 chains if I set the speed to 2Gbit? Or must ESH4 shelves be on a separate chain? All disks are FC, I am not trying to mix SATA and FC shelves.
Steve Losen scl@virginia.edu phone: 434-924-0640
University of Virginia ITC Unix Support