Thank you! Thanks everyone. I hope netapp can make modifications.
On May 24, 2017, at 8:46 AM, Brad Thompson brad.thompson877@gmail.com wrote:
I agree with Tim. Honestly it seems that the KB article has the wrong command listed, or maybe just not enough info listed about using said command. I imagine if you were to add a disk count that would put the aggr over 16TB then the command in the KB might work.
Here is a test from my lab box where the check was performed.
FAS3270A> priv set advanced Warning: These advanced commands are potentially dangerous; use them only when directed to do so by NetApp personnel. FAS3270A*> FAS3270A*> FAS3270A*> aggr 64bit-upgrade start aggrtest -mode check Checking for additional space required to upgrade all writable 32-bit volumes in aggregate aggrtest (Ctrl-C to interrupt)......
Upgrading a volume to 64-bit consumes additional free space in the volume. The following table shows the space usage after each volume is upgraded to 64-bit:
Volume Name Total Used Available Capacity
voltest 100MB 5448KB 94MB 5%
To initiate the 64-bit upgrade of aggregate aggrtest, run this command with the "normal", "grow-reserved", or "grow-all" option.
If you use the "grow-reserved" or "grow-all" option, volume sizes will be increased automatically as needed during the upgrade.
If I ran the commands from the KB I got the same output you did. Running the command as seen above was the only way I could get the check to run.
-Brad
On Tue, May 23, 2017 at 11:15 PM, tmac tmacmd@gmail.com wrote: what about this: priv set advanced aggr 64bit-upgrade start Aggr1
or
aggr 64bit-upgrade start Aggr1 -mode check
--tmac
Tim McCarthy, Principal Consultant Proud Member of the #NetAppATeam
I Blog at TMACsRack
On Tue, May 23, 2017 at 9:54 PM, Iluhes iluhes@yahoo.com wrote: Tim, Thanks for fast response
online raid_dp, aggr nosnap=on, raidsize=11 32-bitOn Tuesday, May 23, 2017 8:18 PM, tmac tmacmd@gmail.com wrote:
Is the volume already 64-bit? Maybe it is being ignored because it is already 64-bit?
--tmac
Tim McCarthy, Principal Consultant Proud Member of the #NetAppATeam I Blog at TMACsRack
On Tue, May 23, 2017 at 8:40 PM, Iluhes iluhes@yahoo.com wrote: Hi Folks, NetApp Release 8.2.4P6 7-Mode
Running #aggr add Aggr1 -64bit-upgrade check
aggr add: Neither a count of disks nor a list of disks to add to the aggregate was specified.
Running with # of disk seem to be also not running check
#aggr add Aggr1 -64bit-upgrade check 6 Note: preparing to add 4 data disks and 2 parity disks. Continue? ([y]es, [n]o, or [p]review RAID layout) p
Is "check" no longer an option in 8.2.4?
Virus-free. www.avast.com
Toasters mailing list Toasters@teaparty.net http://www.teaparty.net/ mailman/listinfo/toasters
Toasters mailing list Toasters@teaparty.net http://www.teaparty.net/mailman/listinfo/toasters