Hmm. And you're on a version fairly close to ours. For us, NFS service actually recovered on its own -- after 30 minutes or so of "impact". Then it would be stable for a while and the issue would return. Rinse & repeat. Rebooting the controller did expedite recovery (though didn't prevent reocurrence).
We don't have a bug #, but did manage to capture a perfstat during one of the outages. We'll keep pushing on this...
Ray
On Wed, Sep 17, 2014 at 05:20:53PM -0700, Fletcher Cocquyt wrote:
We experienced the same NFS outage on a 2240 SATA aggr running 8.1.2. We ended up having to reboot the filer to recover NFS service. Is there a bug number for this issue? We opened a case but were told without a perfstat from the incident there was not much diagnostic info to go on.
thanks
On Sep 17, 2014, at 4:48 PM, Ray Van Dolson rvandolson@esri.com wrote:
I'll add that this issue seems very similiar:
https://communities.netapp.com/thread/12180
Though on a much older version of ONTAP (well, presumably -- the OP doesn't exactly state what they're running, but it is from 2010).
Ray
On Wed, Sep 17, 2014 at 04:04:23PM -0700, Ray Van Dolson wrote: Thanks for the reply. ndmpcopy is probably faster, though we've used single-file snaprestore in the past with no issues (but hadn't used it since upgrading to 8.1.2P4).
It's interesting to me that no other functionality on the filer (at least as far as we're aware) was impacted other than NFS.
We'll work with IBM to see if this is a known issue or something new. Suppor tells us the behavior we observed is absolutely not expected.
Ray
On Wed, Sep 17, 2014 at 08:50:44PM +0000, Jordan Slingerland wrote: I have heard of some issues with single file snap restore in 'older' version...maybe fixed in 8.2?, I am not sure. I always use ndmpcopy over snapstore when possible. I would suggest that as an alternative, though I know that does not exactly answer your question.
--Jordan
-----Original Message----- From: toasters-bounces@teaparty.net [mailto:toasters-bounces@teaparty.net] On Behalf Of Ray Van Dolson Sent: Wednesday, September 17, 2014 4:35 PM To: toasters@teaparty.net Subject: Single-file Snaprestore Causing Performance Impact?
Hi all;
Running 8.1.2P4 in 7-Mode on an IBM N6240. We initiated a couple of single-file snaprestores which ran for 15+ hours on some busy SATA-based aggregates). During that time, we experienced intermittent issues connecting to the NFS services on this filer. Issues would clear up after a while (minutes or tens of minutes) and then return an hour or so later.
We killed the snaprestores during one of the outages and observed a full recovery of the NFS service. It may have been coincidental.
Anyone aware of snaprestore (specifically, single-file restores) causing cascading impacts?
OnCommand doesn't show any additional spike in CPU, disk activity, etc....
Thanks, Ray