vol show -field policy -vserver ocna06c-nfs (volume show)vserver volume policy ----------- ----------------- ---------- test-nfs test1 testvm .....
(network interface show) Logical Status Network Current Current IsVserver Interface Admin/Oper Address/Mask Node Port Home----------- ---------- ---------- ------------------ ------------- ------- ----test-nfs test-nfs_nfs_lif1 up/up 10.9.9.9/24 testA a0a-670 true
Vserver Name: test-nfs Logical Interface Name: test-nfs_nfs_lif1 Role: data Data Protocol: nfs Home Node: testA Home Port: a0a-670 Current Node: testA Current Port: a0a-670 Operational Status: up Extended Status: - Numeric ID: 1039 Is Home: true Network Address: 10.9.9.9 Netmask: 255.255.255.0 Bits in the Netmask: 24 IPv4 Link Local: - Routing Group Name: d10.9.9.0/24 Administrative Status: up Failover Policy: nextavail Firewall Policy: mgmt Auto Revert: false Sticky Flag: false Fully Qualified DNS Zone Name: none DNS Query Listen Enable: false Load Balancing Migrate Allowed: false Load Balanced Weight: load Failover Group Name: system-defined FCP WWPN: - Address family: ipv4 Comment: - eth0 Link encap:Ethernet HWaddr 00:50:56:B4:7D:A9 inet addr:10.9.9.3 Bcast:10.9.9.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:1871372 errors:0 dropped:0 overruns:0 frame:0 TX packets:2047231 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:605262141 (577.2 MiB) TX bytes:286957218 (273.6 MiB) lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 UP LOOPBACK RUNNING MTU:65536 Metric:1 RX packets:47212 errors:0 dropped:0 overruns:0 frame:0 TX packets:47212 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:10208922 (9.7 MiB) TX bytes:10208922 (9.7 MiB) [root@/]# netstat -rnKernel IP routing tableDestination Gateway Genmask Flags MSS Window irtt Iface10.9.9.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0 eth00.0.0.0 10.9.9.1 0.0.0.0 UG 0 0 0 eth0 The NFS vserver only has visiabilty to DATA interface...how can route would go somewhere else?
On Monday, December 22, 2014 3:10 PM, tmac tmacmd@gmail.com wrote:
So, got this data so far: appears to be using a0a (single mode e0b/e0d, e0b active, e0d not so much with IP distribution)10.9.9.9:/test1 on /mnt1 type nfs (rw,bg,hard,intr,rsize=32768,wsize=32768,vers=3,tcp,timeo=600,addr=10.9.9.9) --> tried both intr and nointrConfirmed v3 is ENABLED and all v4+ are disabled on the NFS vserverTCP & UDP are both enabled on vserver No Jumbo frames No blatant errors showing via netstat -i on the client or netapp side Flow control appears off from cdot point of view. have the export-policy rule data Waiting for this data: vol show -field policy Wondering if it might be related. --> Iluhes Please send:vol show -field policynet int show -vserver test-nfs -instance(would like to see all the network interface details) Also send the client-side "ifconfig -a" for all interfaces, including netstat -rn maybe there is a bad route someplace. --tmac Tim McCarthyPrincipal Consultant
On Mon, Dec 22, 2014 at 3:50 PM, Parisi, Justin Justin.Parisi@netapp.com wrote: Are you specifying NFSv3 in the mount? Or using NFSv4? I’d suggest getting the info tmac mentioned. Like others have said, impossible to solve with such limited info. From: Iluhes [mailto:iluhes@yahoo.com] Sent: Monday, December 22, 2014 3:49 PM To: Parisi, Justin; Alexander Griesser Cc: Toasters Subject: Re: new cdot NFS vserver. NFS mount point hang on I/O New clients. RHEL 6.6 On Monday, December 22, 2014 2:43 PM, "Parisi, Justin" Justin.Parisi@netapp.com wrote: How old are your clients? From:toasters-bounces@teaparty.net [mailto:toasters-bounces@teaparty.net]On Behalf Of Iluhes Sent: Monday, December 22, 2014 3:42 PM To: Alexander Griesser Cc: Toasters Subject: Re: new cdot NFS vserver. NFS mount point hang on I/O Thanks.I can get unmounted and remounted, but I cannot overcome the issue of copy any files into filesystem, or writing anything to it. Nothing besides mkdir and touch works..Something is wrong with the setup... On Monday, December 22, 2014 2:37 PM, Alexander Griesser ag@anexia.at wrote: umount -l /mountpoint should at least get you going on the box again.When the filesystem had bren mounted on linux, can you post the output of the 'mount' command so we can see the mount options in use? best,Alexander GriesserHead of Systems Operations ANEXIA Internetdienstleistungs GmbH E-Mail: ag@anexia.atWeb: http://www.anexia.at%C2%A0Anschrift Hauptsitz Klagenfurt:Feldkirchnerstraße 140, 9020 KlagenfurtGeschäftsführer: Alexander WindbichlerFirmenbuch: FN 289918a | Gerichtsstand: Klagenfurt | UID-Nummer: AT U63216601 Am 22.12.2014 um 21:16 schrieb Iluhes iluhes@yahoo.com: Yes Jordan, have to do fuser -km actually...but even that works 50% of the time. It will hang the box On Monday, December 22, 2014 1:51 PM, Jordan Slingerland Jordan.Slingerland@independenthealth.com wrote: Does not solve the root of your problem, but can you umount –f ? From:toasters-bounces@teaparty.net [mailto:toasters-bounces@teaparty.net]On Behalf Of Iluhes Sent: Monday, December 22, 2014 2:42 PM To: Toasters Subject: new cdot NFS vserver. NFS mount point hang on I/O Hi Folks,New cdot isntall, new NFS vserver. NFS shares can be mounted OK on linnux and solaris clients.I can mkdir and touch files. Copy or move or DD or any I/O operation completly hangs the mount point, the process cannot be Control-C, and kill -9 does not even help
_______________________________________________ Toasters mailing list Toasters@teaparty.net http://www.teaparty.net/mailman/listinfo/toasters _______________________________________________ Toasters mailing list Toasters@teaparty.net http://www.teaparty.net/mailman/listinfo/toasters