Hallo,
maybe my initial situation was not clear:
On the "main site" I spent VfilerA a new disk. Volume1 before "vol add" : 201 GB Volume1 after "vol add" : also 201 GB
vol status -b Volume1: Vol Size (blocks) FS Size (blocks) ----------------- ---------------- 76996480 61597184
The filer notified that "..the disk was successfully added to volume Volume1" IMHO this results because Volume1 is in "snapmirrored-state" an the option "fs_size_fixed" is set "on".
On the "desaster site" I spent VfilerA' (vfiler dr) also a new disk for volume Volume1. Same results.
I think I must break the mirror but is this possible without side effects on VfilerA because he is in "vfiler dr"
Thanks a lot
Michael
Fox, Adam Adam.Fox@netapp.com schrieb :
You don't need to do this. It looks like you are doing Volume SnapMirror. All you have to do is add the disks to both volumes. You won't see the change on the destination until the next update, then the destination will become the size of the source.
-- Adam Fox GS Tools Developer adamfox@netapp.com
-----Original Message----- From: Uehara, Tsuneyuki (Gen) [mailto:tsuneyuki.uehara@gs.com] Sent: Tuesday, June 15, 2004 7:23 AM To: 'toaster@chopel.de'; toasters@mathworks.com Subject: RE: Enlarge a volume owned by a vfiler
We perform "snapmirror quiesce" then "snapmirror break" then turn off "fs_size_fixed".
# Gen Uehara
-----Original Message----- From: owner-toasters@mathworks.com [mailto:owner-toasters@mathworks.com] On Behalf Of toaster@chopel.de Sent: Tuesday, June 15, 2004 10:12 PM To: toasters@mathworks.com Subject: Enlarge a volume owned by a vfiler
Hi,
I have a problem to enlarge a volume owned by a "dr"-vfiler.
Vfiler1 Vfiler1 (dr backup) |--> vol1 |-->vol1
It was possible to add a disk to vol1 on both sites. But I can't disable the volume option "fixed fs_size", because vol1 is in "snapmirrored-state".
How can I enlarge the volume without deleting the dr-filer?
Thanks for help,
Michael