Hello Toasters
I have a FAS2020 Active/Active system with one DS14MK2-AT shelf attached. This weekend I intend to hot-add an additional DS14MK2-AT shelf. However, I believe the existing loop is cabled incorrectly. I'm hoping someone on this list can give me some pointers to confirm whether the cabling can be corrected without taking the filers offline. I really want to fix the cabling before I attempt to hot-add the new shelf. The current cabling is:
CNTRL-A/0a -> AT-FCX-A -> CNTRL-A/0b And CNTRL-B/0a -> AT-FCX-B -> CNTRL-B/0b
According to the FAS2020 installation flyer, the end of each loop path should terminate with the opposite controller's 0b port (not the same controller as above). Is it possible/advisable to disconnect the cable from both controllers' 0b port and swap them over to get to the correct setup? So long as I don't lose one of the AT-FCX modules during the switchover it seems like it would be okay.
I'm going to open a case with support but I was hoping some of the experts on this list might have some thoughts/recommendations/horror stories you can share?
Thanks Steve
DISCLAIMER: The information contained within this electronic mail is confidential and may be legally privileged and it is intended for the addressees only. If you have received this message in error and you are not the intended recipient please notify the sender immediately and delete the message. Any review of the contents, dissemination or distribution of such, copying or other use of this communication or the information within is strictly prohibited. For further information or should you wish to discuss this with us, please email legal@iconsultci.com.