You need to enable LACP on your VIF. This requires at least DOT 7.2.1 Check the DOT command reference on the now site to see how to configure yout VIF for LACP
This page helped me for configuring the Cisco side. http://www.cisco.com/en/US/products/hw/switches/ps708/products_configura tion_guide_chapter09186a0080160a03.html
Still evaluating performance so I can't say if this or PAgP is better. YMMV
Good luck
-----Original Message----- From: owner-toasters@mathworks.com [mailto:owner-toasters@mathworks.com] On Behalf Of tmac Sent: Tuesday, March 27, 2007 12:01 PM To: toasters@mathworks.com Subject: LACP and filers
Has anyone successfully configured LACP for channeling of interface to a Cat6500? What is commands are need on the Switch (IOS)? What needs to be done on the filer?
I played with this, but was uncertain. Can anyone shed some light?
thanks