No that won't work. If you are configuring cDOT, at least two ports per controller are reserved for the cluster network (e0a & e0c) This leaves e0b and e0d available for normal network access
The recommended configuration is to use all four ports for the cluster network (e0a, e0b, e0c & e0d). In this case, if you need/want 10gig network connections you would need an extra 10gig card
AS indicated earlier in this thread, from each controller: a0a should be a multimode_lacp VIF and contain: e0b -> switch 1 e0d -> switch 2
Then you can create your VLANs: a0a-123, a0a-456
Place your LIFs on the tagged VLANs
Create a failover group for node-01:a0a-123 and node-02:a0a-123 Create a failover group for node-01:a0a-456 and node-02:a0a-456
Assign the failover group to the appropriate LIF
PS: DO NOT FORGET to disable spanning tree on the switch ports. --> spanning tree protocol should only be enabled on ports connected to other switches. --> it is not needed on ports connected to en hosts --> in a cluster failover event it could take an extra 45 seconds for a port to become available.(not good) --> remember to use the right version of the command. if it is a trunk, you usually need that on the line
--tmac
*Tim McCarthy* *Principal Consultant*
On Wed, Apr 8, 2015 at 11:36 PM, Francis Kim fkim@berkcom.com wrote:
You can also tie the four links into a single interface group and carve it up into multiple VLANs.
What ports are you going to use for the cluster interconnect? I assume you're ordering a switchless cluster of two nodes?
*Francis Kim *| Engineer 510-644-1599 x334 | fkim@berkcom.com
*BerkCom* | www.berkcom.com NetApp | Cisco | Supermicro | Brocade | VMware
On Apr 8, 2015, at 3:51 PM, Sayla, Mustafa MSAYLA@mesirowfinancial.com wrote:
We are looking to buy new FAS8040 and configure it with CDOT. I am looking for network recommendation with Cisco 6509 VSS. 8040 has four 10G ports per controller and I want to use all four ports to create an interface group with two VLAN, using VLAN tagging. I want 2 ports to go to one VSS switch and 2 ports to go to other VSS switch so I have switch redundancy also. I am not sure if it is doable since I am going to two different switches. Any recommendation is appreciated.
Mustafa *Visit us on the Web at mesirowfinancial.com http://mesirowfinancial.com/*
*This communication may contain privileged and/or confidential information. It is intended solely for the use of the addressee. If you are not the intended recipient, you are strictly prohibited from disclosing, copying, distributing or using any of this information. If you received this communication in error, please contact the sender immediately and destroy the material in its entirety, whether electronic or hard copy. Confidential, proprietary or time-sensitive communications should not be transmitted via the Internet, as there can be no assurance of actual or timely delivery, receipt and/or confidentiality. This is not an offer, or solicitation of any offer to buy or sell any security, investment or other product.*_______________________________________________ Toasters mailing list Toasters@teaparty.net http://www.teaparty.net/mailman/listinfo/toasters
Toasters mailing list Toasters@teaparty.net http://www.teaparty.net/mailman/listinfo/toasters