Chaim,
Pulling disks from a shelf and putting them back in won't change the shelf ID they think they are assigned to. In your prior post you showed you had a stack of shelves with ID 0-4. When you do the disk show command, do you see 2 shelves with ID 0 or is it missing a shelf? You could always remove a disk or 2 and run it again to make sure which shelf 0 you are really seeing. From there you can go back and verify connectivity to the appropriate shelf.
Jeff
On Thu, Nov 17, 2011 at 6:34 PM, Chaim Rieger chaim.rieger@gmail.com wrote:
I have a shelf that displays ID 4 however when i do show disk they come up as belonging to ID 0. This probably happened because the ID was changed, then powered off, then connected to the loop, then powered on. Just a guess...
I am not comfortable with removing a full shelf from a loop (even though all these disks are marked as spares currently) Therefore my question is, if i remove one disk at a time, and reseat it. will it come up as ID 4, or ID 0 ?
Toasters mailing list Toasters@teaparty.net http://www.teaparty.net/mailman/listinfo/toasters