Hello everyone,
The purpose of this email is to ask if I can configure multiple IP addresses per physical interface on an F330. If it is possible I did not see reference to it in the manuals. The reason I am asking about this may be of interest to some, though, so an explanation follows. Upon installing a Cisco Catalyst network switch, communication between the filer and our staff machine went bad. I am the only one using the filer from the staff machine so I have only researched the problem as time allows. The staff machine is a Sun Ultra 2 running Solaris 2.5.1, the filer is a F330 running 4.0.2c (?) and I have NFS over TCP turned off. The first thing I did was have our network guys manually configure all the ports on the Catalyst, since this list had discussed the general problem with ethernet autonegotiation. It did not help. The next thing I did was replace the ethernet cable from the staff machine to the Catalyst. If the staff machine was the only device having a problem, it stood to reason. No effect. Next, I began a long series of large packet pings between various machines connected to the Catalyst. As a result of that, I have discovered that a Catalyst does not like multiple subnets and drops from 12 to 22 percent of cross-subnet packets. My network guru claims that the Catalyst switches at layer 2 and so the IP address should not matter, but that certainly is at odds with what I am seeing. I'll let the list know how this turns out OR if you have a Catalyst serving multiple subnets without problem, please let me know how it is configured. Just for the record, the filer and its two main clients are on three successive ports on the Catalyst.
Regards,
David K. Drum david@more.net