Shouldn't there be a sequence when turning on attached devices?
James
-----Original Message----- From: owner-toasters@mathworks.com [mailto:owner-toasters@mathworks.com] On Behalf Of graziee Sent: Wednesday, September 19, 2007 6:07 AM To: tmac Cc: Bryano; toasters@mathworks.com Subject: Re: Reconnect to tape drive
for FC that doesnt show up automatically, you can do offline/online to rescan the adapters:
fcadmin offline <adapter> fcadmin online <adapter>
gracie
On Sep 19, 2007, at 8:46 PM, tmac wrote:
Is it FC or SCSI? (probably SCSI, since FCAL shows up when it is ready)
go to "priv set diag"
storage disable -f adapter Xy
(where X is the slot number and y is the channel, if applicable, like 8a)
Wait a few seconds (like 10) and then:
storage enable adapter Xy
See if it comes back....
--tmac
On 9/19/07, Bryano tgbryano@gmail.com wrote:
Hi,
We had a power failure the other day (dont ask...!) and as a result it looks as though our filer was brought back up before the tape library was started. One of the drives in the library is directly connected to the filer however it is not showing as being available, when I run a sysconfig -t no tape drive is shown. How can I get the filer to see the tape drive without rebooting it again??
Thanks
View this message in context: http://www.nabble.com/Reconnect-to- tape-drive-tf4480451.html#a12775717 Sent from the Network Appliance - Toasters mailing list archive at Nabble.com.
-- --tmac
RedHat Certified Engineer #804006984323821