I get the same behavior regardless of if I try to mount with udp or tcp.
On Thu, Apr 1, 2010 at 11:53 PM, Steve Francis sfrancis@logicmonitor.comwrote:
You could also switch to TCP mounts, instead of UDP (which I'm just assuming you are currently using.) Fastpath should be the answer, but with fastpath off, UDP packets that were sent to VIF1, that are replied to by VIF2 (due to the filers route table), will have a source address of VIF2 (and hence be dropped by the mounting system.) TCP packets will be source with the IP address of the destination interface on the filer, regardless of the egress interface.
So switching to TCP mounts will make your current config work rapidly, but not necessarily with the transit paths as you want.
(The above is characteristic of UDP - not just NetApps.)