Hi All
 
We have 9 x F760 Netapp Filers, 4 in Cluster Mode and the 9th one is what we have reserved for Snapmirror.
 
We currently snapmirror volumes from these 8 filers to the backup filer.   However, All existing filers have the old FC9 Disk Shelves with 36 gig disks in, and the new F760 Backup Filer has the new DC14 Disk Shelves with 72 gig drives.   
 
What should have been a disk for disk snapmirror configuration, either by having 36 gig to 36 gig or 36 gig x 2 to 72 gig disk, has become more complicated as the new disks have a different Zone.  The new zone makes the new 72 gig disks slightly smaller than 2 x old 36 gig disks.
 
I was wondering if anyone else might have encountered this problem yet, and if there is any workarounds as to disk zoneing, etc etc.
 
Thanks
KEVIN
-----Original Message-----
From: Jay Newton [mailto:jnewton@chkenergy.com]
Sent: 04 September 2001 21:05
To: 'toasters@mathworks.com'
Subject: Snapshots of QTREEs

Is there a way to snapshot an individual QTREE from command line or must it be the entire volume.  I have a volume set up for databases and I want to snapshot from command line individual QTREEs that represent different types of databases.  Any help would be appreciated!


Jay Newton
Systems Engineer - Chesapeake Operating
(405)810-2683
(405)879-9578 fax



********************************************************************************************
" This message contains information that may be privileged or confidential and
is the property of the Cap Gemini Ernst & Young Group. It is intended only for
the person to whom it is addressed. If you are not the intended recipient, you
are not authorized to read, print, retain, copy, disseminate, distribute, or use
this message or any part thereof. If you receive this message in error, please
notify the sender immediately and delete all copies of this message ".
********************************************************************************************