Can't hurt to rename it beforehand, but I am pretty sure it is going to show up as "aggr0(1)" on the otherside so it should be a non-issue
-----Original Message-----
From:
toasters-bounces@teaparty.net [
mailto:toasters-bounces@teaparty.net] On Behalf Of Martin
Sent: Tuesday, February 02, 2016 2:44 PM
To:
toasters@teaparty.netSubject: RE: Moving shelves with root aggr and root vol (7-mode) from one Filer to another
Hi Andre, Douglas and Mike
I have to add a SAS card on the destination Filer and have a maintenance window to take it down, so can go into maintenance mode. As Mike mentioned I can check the various stages of adding the disks and I will just reassign the disks on the destination Filer.
I'll also use "disk show -p" to confirm all the disks have two paths post maintenance.
As Andre suggested I'm going to rename the vol0 and aggr0 on the source Filer.
Luckily both Filers are on identical Ontap versions and I'm going to update the disk and shelf firmware before in a separate maintenance (although I believe they are currently identical).
Thanks for the advice
Martin
--
View this message in context:
http://network-appliance-toasters.10978.n7.nabble.com/Moving-shelves-with-root-aggr-and-root-vol-7-mode-from-one-Filer-to-another-tp27409p27413.htmlSent from the Network Appliance - Toasters mailing list archive at
Nabble.com.
_______________________________________________
Toasters mailing list
Toasters@teaparty.nethttp://www.teaparty.net/mailman/listinfo/toasters
_______________________________________________
Toasters mailing list
Toasters@teaparty.net
http://www.teaparty.net/mailman/listinfo/toasters