Anyone have a 4-node 2240 cluster running 8.2.x?

If so, could you tell me if failover says enabled or disabled when you do a “cluster kernel-service show” in diag mode.

I’ve had a performance case open for months on this cluster and I noticed recently that this cluster says failover is disabled but our 4 node 3220 cluster says enabled.

LCNA2::> set d

Warning: These diagnostic commands are for use by NetApp personnel only.

Do you want to continue? {y|n}: y

LCNA2::*> cluster kernel-service show

Node       State    Ver  Failover  Dump      FSM-State

---------- -------- ---- --------- --------- ---------

LCNA2-01   enabled  1    disabled  enabled   CLAM_CORE_ST_NONMASTER_WAITING_FOR_BACKOFF_TIMEOUT

LCNA2-02   enabled  1    disabled  enabled   CLAM_CORE_ST_NONMASTER_WAITING_FOR_BACKOFF_TIMEOUT

LCNA2-03   enabled  1    disabled  enabled   CLAM_CORE_ST_MASTER_WAITING_FOR_HB_TIMEOUT

LCNA2-04   enabled  1    disabled  enabled   CLAM_CORE_ST_NONMASTER_WAITING_FOR_BACKOFF_TIMEOUT

4 entries were displayed.

Thanks

mark