Try this works for me
 
Computers and terminals are typically DTE (Data Terminal Equipment) devices.
 
DTE Adapter Wiring
DB-9  DB-25     Signal Function                        Adapter               RJ-45
8         5             CTS Clear To Send                 Blue                        1
1         8             DCD Data Carrier Detect        Orange                    2
2         3             RD Received Data                   Black                      3
5         7             SG Signal Ground                    Red                         4
5         7             SG Signal Ground                    Green                      5
3         2             TD Transmitted Data               Yellow                     6
4         20           DTR Data Terminal Ready       Brown                     7
7         4             RTS Request To Send             White                       8
6         6             DSR Data Set Ready               - - (see notes below )
9         22           RI Ring Indicator                      - - ( probably forget this one )
 
Some DTE devices require the DSR (Data Set Ready) signal. This signal is usually provided by the DCE device. If you have a DTE device (such as a terminal) that requires the DSR signal, wire pins 20 and 6 (4 and 6 on a DB-9 connector) together. This way, the DTE device will receive the DSR signal from itself when it asserts the DTR signal.
-----Original Message-----
From: DFinn@studentadvantage.com [mailto:DFinn@studentadvantage.com]
Sent: Mon 19/05/2003 19:55
To: Jason.Santos@pinnaclewest.com
Cc: toasters@mathworks.com
Subject: RE: sem-OT : rj45->db9 pin-out to connect to netapps console port

That's strange.  I tried one of those and it didn't work.  It's a black
rj45->db9 connector labeled TERMINAL and it's the one I was using to attach
to the serial port of a laptop to console into the cisco.  I know the
console port on the netapp works fine though because I can get into that
with a serial cable and a laptop.

-----Original Message-----
From: Jason.Santos@pinnaclewest.com
To: DFinn@studentadvantage.com
Sent: 5/19/03 1:52 PM
Subject: RE: sem-OT : rj45->db9 pin-out to connect to netapps console port

They are pinned out the same as the adapters that came with the 2511
(labeled Terminal, I think).  I have some at home, don't have one here,
I can e-mail you later if you still didn't find it.

--
Jason Santos
Sr. Unix System Administrator
APS/Pinnacle West
Phoenix, AZ USA


-----Original Message-----
From: DFinn@studentadvantage.com [mailto:DFinn@studentadvantage.com]
Sent: Monday, May 19, 2003 10:32 AM
To: toasters@mathworks.com
Subject: sem-OT : rj45->db9 pin-out to connect to netapps console port


I've decided to try and use the Cisco 2511-RJ that we currently have in
place for our sun gear and connect the netapps to that for network
console connections.  I picked up some rj45->db9 connectors that need to
be pin'd out.  Does anyone know how these are pin'd out offhand?

Thanks
Dan