yes, i neglected to mention we did a clean shutdown shortly after. this was coordinated as a way to fix an urgent need which it sounded like the original poster had in regards to sending a loaner shelf back.
it did function fine without any issues until an approved downtime window could be scheduled.
in most of our environments we have zero ability for any downtime scheduled or otherwise which is really killing us with a current shelf bug causing drives to randomly go amber and support recommends power cycling the shelf to correct it + updated firmware--but thats a whole other story.
--daniel
--
Daniel Leeds
Manager, Storage Operations
Edmunds, Inc.
1620 26th Street, Suite 400 South
Santa Monica, CA 90404
310-309-4999 desk
310-430-0536 cell
-----Original Message-----
From: Jeff Mohler [mailto:speedtoys.racing@gmail.com]
Sent: Thu 11/13/2008 3:01 PM
To: Leeds, Daniel
Cc: Nils Vogels; Ray Van Dolson; toasters@mathworks.com
Subject: Re: Removing a shelf.
Daniel:
I would check with support, IIRC, hot removing a shelf is _really_
frowned upon, and can cause mapping issues that can lead to
_requiring_ you to power down all nodes and shelves to correct.
Even in failover mode, shelf mapping is persistent.
https://now.netapp.com/Knowledgebase/solutionarea.asp?id=kb40710
> Daniel Leeds
> Manager, Storage Operations
> Edmunds, Inc.
> 1620 26th Street, Suite 400 South
> Santa Monica, CA 90404
>
> 310-309-4999 desk
> 310-430-0536 cell
>
>
>
> -----Original Message-----
> From: owner-toasters@mathworks.com on behalf of Nils Vogels
> Sent: Thu 11/13/2008 1:16 PM
> To: Ray Van Dolson
> Cc: toasters@mathworks.com
> Subject: Re: Removing a shelf.
>
> Hey Ray,
>
> On Thu, Nov 13, 2008 at 9:31 PM, Ray Van Dolson <rvandolson@esri.com> wrote:
>>
>> An aggregate spans two shelves, one of which is the shelf that needs to
>> be returned. This aggregate contains a FlexVol currently in use. I'd
>> like to preserve the FlexVol but remove the shelf.
>
> If you can afford the downtime, you could offline the aggregate
> concerned, swap the disks into the shelf that can remain, and online
> the aggregate again. Should be a few minutes.
>
> Another way, which does take a lot longer, is to use "disk replace" to
> copy the used disks from their old position to their new ones. No
> downtime, but the disks get copied one at a time, which can be a few
> hours.
>
> HTH & HAND
>
> --
> Simple guidelines to happiness:
> Work like you don't need the money,
> Love like your heart has never been broken and
> Dance like no one can see you.
>
>