It does not say that SSD isn't supported, but I've heard that from multiple people: "All locally attached storage that is managed by ONTAP Select must be of like kind with respect to storage type and speed" is
all we get in writing.
So if we only have SSDs on the servers, we can't get support for ontap select?
From: Parisi, Justin [mailto:Justin.Parisi@netapp.com]
Sent: September-07-16 2:44 PM
To: NGC-tbar-berkcom.com; BERNTSEN Basil (EXT) ResgGtsInt; toasters@teaparty.net
Subject: RE: Ontap SELECT SSD
No SSD support in ONTAP Select yet. That TR doesn’t explicitly say it’s supported; it just mentions that other solutions need SSD:
Although some software-defined solutions require the presence of an SSD to act as a higher speed writestaging device, ONTAP Select uses a hardware RAID controller
to achieve both a write performance boost and the added benefit of protection against physical drive failures by moving RAID services to the hardware controller.
From: toasters-bounces@teaparty.net [mailto:toasters-bounces@teaparty.net]
On Behalf Of Tony Bar
Sent: Wednesday, September 07, 2016 2:37 PM
To: BERNTSEN Basil; toasters@teaparty.net
Subject: RE: Ontap SELECT SSD
Basil –
For ONTAP select all the storage must be of the same type and speed (e.g. 7200 RPM NL-SAS, 10000 RPM SAS, SSDs) so you can’t mix and match say 20x 4TB NL-SAS drives and
10x SSDs in the same ONTAP select VM. I haven’t seen or heard about any restrictions on disk type though and the TR you linked definitely implies that they’re usable.
As far as flash optimization goes, I am pretty sure that only applies to AFF filers and not ONTAP 9.0 in general so that would seem to rule out ONTAP Select.
Thanks!
From:
toasters-bounces@teaparty.net [mailto:toasters-bounces@teaparty.net]
On Behalf Of BERNTSEN Basil
Sent: Wednesday, September 7, 2016 11:24 AM
To: toasters@teaparty.net
Subject: Ontap SELECT SSD
Hi folks,
I was told by someone on my account team that SSD isn't "allowed" on Ontap SELECT. That said, I found in TR 4517, page 9, (http://www.netapp.com/us/media/tr-4517.pdf)
that in fact we can use SSDs. Anyone here know the whole story?
·
If I attach a bunch of SSDs to a RAID card and present them to an Ontap SELECT VM, can I use them?
·
Will it try to use them like spindles, without any of the new 9.0 flash optimizations?
Thanks!
Basil Berntsen
Société Générale
*************************************************************************
This message and any attachments (the "message") are confidential, intended solely for the addressee(s), and may contain legally privileged information. Any unauthorized use or dissemination is prohibited. E-mails are susceptible to alteration. Neither SOCIETE
GENERALE nor any of its subsidiaries or affiliates shall be liable for the message if altered, changed or falsified. Please visit
http://sgasdisclosure.com for important information regarding SG Americas Securities, LLC (“SGAS”). Please visit
http://swapdisclosure.sgcib.com for important information regarding swap transactions with SOCIETE GENERALE.
*************************************************************************
*************************************************************************
This message and any attachments (the "message") are confidential, intended solely for the addressee(s), and may contain legally privileged information. Any unauthorized use or dissemination is prohibited. E-mails are susceptible to alteration. Neither SOCIETE GENERALE nor any of its subsidiaries or affiliates shall be liable for the message if altered, changed or falsified. Please visit http://sgasdisclosure.com for important information regarding SG Americas Securities, LLC (“SGAS”). Please visit http://swapdisclosure.sgcib.com for important information regarding swap transactions with SOCIETE GENERALE.
*************************************************************************