Justin, thanks for the feedback

What makes step 13 (cf giveback) triggering another reboot of the SAME node A is step 12 reads like that has already been accomplished for node A

so does node A reboot twice, then when you repeat the procedure, node B reboots twice?

thanks
-- 
Fletcher



On Feb 2, 2012, at 11:20 AM, Parisi, Justin wrote:

In a takeover/giveback scenario, there are two reboots.
 
The first reboot is the takeover. The second reboot is the giveback.
 
From: toasters-bounces@teaparty.net [mailto:toasters-bounces@teaparty.net] On Behalf Of Fletcher Cocquyt
Sent: Thursday, February 02, 2012 1:52 PM
To: toasters@teaparty.net
Subject: clarification about reboots during NDU
 

Hi - can someone clarify this from pg 56 of the upgrade guide - 

for instance, if step 12 causes A to "reboot the system using the new firmware and software"
 
WHY in step 13 does the cf giveback ALSO "cause system A to reboot with the new system configuration?"
 
Are there really 2 reboots ?
 
thanks

 

12. Enter the following command to reboot the system using the new firmware and software:

bye

13. Choose the option that describes your configuration.

<image001.png>
<image002.png>

If FCP or iSCSI...

Is not in use in system A

Is in use in system A

Then when the "Waiting for giveback" message appears on the console of system A...

Enter the following command at the console of system B:

cf giveback

Wait for at least eight minutes to allow host multipathing software to stabilize, then enter the following command at the console of system B:

cf giveback

<image001.png>
<image002.png>
<image001.png>
<image002.png>
<image001.png>
<image002.png>

Attention: The cf giveback command can fail because of open client sessions (such as CIFS sessions), long-running operations, or operations that cannot be restarted (such as tape backup or SyncMirror resynchronization). If the cf givebackcommand fails, terminate any CIFS session or long-running operations gracefully (because the -f option will immediately terminate any CIFS sessions or long-running operations) and then enter the following command (with the -f option):

  cf giveback -f

For more information about the behavior of the -f option, see the cf(1) man page.

The command causes system A to reboot with the new system configuration—a Data ONTAP version and any new system firmware and hardware changes—and resume normal operation as a high-availability partner. 

-- 
Fletcher Cocquyt
Principal Engineer
Information Resources and Technology (IRT)
Stanford University School of Medicine
<image003.jpg>

Email: 
fcocquyt@stanford.edu 
Phone: (650) 724-7485