Make sure that your 3550 model of cisco switch supports 9000 byte mtus... there is  an asic limitation in some models of that particular switch that doesn't support true jumbo frames.

As for setting up etherchannel...

int portchannel-1
switchport access vlan x
switchport mode access
no ip address

int g0/1
channel-group 1 mode on

int g0/2
channel-group 1 mode on

I'm assuming your just creating a plain vanilla etherchannel (not layer 3.)

you can also experiment with various loadbalancing algorithms using

port-channel load-balance x

to see which one works best for you.

Regards,
Max

 
-----Original Message-----
From: Jason Frank
To: Robert Borowicz
Cc: toasters@mathworks.com
Sent: 7/29/2004 1:27 PM
Subject: Re: Cisco settings

We've got the same setup.  Make sure you've set your MTU to 9000 on
both the NetApp and the clients, and make sure the Cisco is configured
for Jumbo frames.

I'd love to know the correct Cisco settings for a multi-mode VIF as
well as Flow Control.

Jason

On Jul 29, 2004, at 2:59 PM, Robert Borowicz wrote:

> I just got my new Gig-E card on the filer working with our two new
> Cisco 3550 Gig switches. Anybody care to share your heartburn and/or
> tuning tips with me?
> 
> 
> Thanks
> 
> -rob
This electronic message, along with any attachments, is intended only for the person or entity to which it is addressed and may contain confidential and/or privileged material.  Any proprietary information or intellectual property contained in this transmission remains the sole and exclusive property of Marshall & Swift or Marshall & Swift/Boeckh.  No right to use any products or services described in this transmission is valid without an executed and paid license agreement. If you received this in error, please reply to advise the sender and delete the material from any computer.