Hey folks, I have a lab box that is a 3020 with 7.3.4.(I know, I should go 7.3.7) and I have an x1005a-r5 (chelsio 10gb) in it.

The network config is a 2 layer vif with leg1 being a multi of 4-1gb ports and leg2 being the 10gb nic. The 2 legs are in a single mode vif favoring the 10gb.

All ports are connected to a stack of extreme networks summit 400-48t switches.  When running over the 10Gb  leg, I cannot get any jumbo frame packets to show crossing the switch. However, if I flip to leg1 (the multi of 1gb) jumbo frames are flying across.

It's tough for me to admit as a former
Netapp SE, but I am stumped. Any thoughts or suggestions?

Sent from my iPhone. Typos are Apple's fault.
_______________________________________________
Toasters mailing list
Toasters@teaparty.net
http://www.teaparty.net/mailman/listinfo/toasters