I installed a Library StorageTek L80 with one drive LTO2 Certance Ultrium 2 connected via SCSI LVD to Filer F840 with Ontap 6.4.3. This release does not support LTO 2 so I dynamically qualified a IBM Ultrium-TD2. Then I emulated Certance Ultrium 2 as IBM Ultrium-TD2 with success.

But a error appears when I try to use LTO2 format (rst4a/h), wich is displayed but not recognized.

Does someone suffer a similar issue?

bafiler01> mt -f rst4a status

Tue Nov 9 20:15:13 ART [scsi.cmd.checkCondition:error]: Device 2a.1: Check Cond

ition: CDB 0x15: Sense Data SCSI:illegal request - (0x5 - 0x26 0x0 0x0)(2).

Tape drive: CERTANCEULTRIUM 2

Status: ready, write enabled

Format: LTO-I tape only 100GB

fileno = 0 blockno = 0 resid = 0

bafiler01> sysconfig -t

Tape drive (2a.1) CERTANCEULTRIUM 2 emulates ULTRIUM-TD2

rst4l - rewind device, format is: LTO-I tape only 100GB

nrst4l - no rewind device, format is: LTO-I tape only 100GB

urst4l - unload/reload device, format is: LTO-I tape only 100GB

rst4m - rewind device, format is: LTO-I tape 200GB cmp

nrst4m - no rewind device, format is: LTO-I tape 200GB cmp

urst4m - unload/reload device, format is: LTO-I tape 200GB cmp

rst4h - rewind device, format is: LTO-II tape only 200GB

nrst4h - no rewind device, format is: LTO-II tape only 200GB

urst4h - unload/reload device, format is: LTO-II tape only 200GB

rst4a - rewind device, format is: LTO-II tape 400GB cmp

nrst4a - no rewind device, format is: LTO-II tape 400GB cmp

urst4a - unload/reload device, format is: LTO-II tape 400GB cmp